Dascom TALLY MIP480 - Page 63

Using Special Mode
4-29
3 Printing new value:
By pressing SETUP/EXIT Key, the adjustment value for the first dot position on the
left side is determined and the adjustment value is saved. The new adjustment value
of the first dot position on the left side is printed. The paper is automatically advanced
for viewing after the printing is complete. After ejecting a form, the message” 1
st
Print
Position = xx” is printed.
4 Exit the setting of the first dot position on the left side mode.
Turn the printer off to exit this mode.
NOTE: ”yy” is new adjustment value.
1 Print Position = yy
st
1 Print Position = xx
st