Dascom TALLY MIP480 - Page 98

Command Sets
C-4
Function Command
Horizontal Control
Space SP
Backspace BS
Carriage return CR
Select 10cpi DC2 :
Elite characters on ESC :
Proportionally spaced characters on/off ESC P (n)
(on: n = 1, off: n = 0)
Vertical Control
Line feed LF
Form feed FF
Advance paper n/216 inch (1 ≤ n ≤ 255) ESC J (n)
Advance paper n/180 inch (in AG mode) ESC J (n)
(1 ≤ n ≤ 255)
Set line spacing to 1/8 lines ESC 0
Set line spacing to 7/72 inch ESC 1
Set line spacing to n/216 inch ESC 3 (n)
(0 ≤ n ≤ 255)
Set line spacing to n/180 inch (in AG mode) ESC 3 (n)
(0 ≤ n ≤ 255)
Preset line spacing to n/72 inch ESC A (n)
(1 ≤ n ≤ 255)
Preset line spacing to n/60 inch (in AG mode) ESC A (n)
(1 ≤ n ≤ 255)
Set line spacing to 1/6 inch or to the value ESC 2
preset by line spacing command ESC A (n)
Change graphics line spacing base to ESC [ \ (m
1
) (m
2
) (t
1
) ... (t
4
)
1/216 or 1/180 inch (for ESC J and ESC 3)
m
1
= 4, m
2
= 0
0 ≤ t
1
≤ 255, 0 ≤ t
2
≤ 255, t
3
= 0
t
4
= 180 or 216
Reverse line feed ESC ]
Tabulation
Horizontal tab execution HT
Set horizontal tabs ESC D (n
1
) ... (n
k
) NUL
The values of n
1
to n
k
in this command are the
ASCII values of the print columns (at the current character
width) at which tabs are to be set.
(1 ≤ n ≤ 255) (1 ≤ k ≤ 28)
Clear all horizontal tabs ESC D NUL
Move print position right by n/120 inch ESC d (n
1
) (n
2
)
(0 ≤ n
1
, n
2
≤ 255) (n = n
1
+ n
2
X 256)