DataCard CR500 Installation And Administrator's Guide

CR500 Instant Issuance System Installation and Administrator’s Guide A-7
Option MG:
None
ISO
Displays the type of magnetic encoder installed.
IC Antenna:
None
Installed
Displays whether the contactless card option is
installed:
 None: A contactless card option is not installed.
 Installed: A contactless smart card option is
used.
IC Contact:
None
ISO Type
Displays whether the contact card option is
installed:
 None: A contact card option is not installed.
 ISO type: The type of contact card option
installed.
Contact IC R/W:
None
Installed
Displays whether the contact card R/W option is
installed:
 None: The R/W option is not installed.
 Installed: An Internal Contacts for External
Reader option is installed.
Bend Remedy HR:
None
Installed
Displays whether the bend remedy option is
installed.
Turn Over:
None
Installed
Displays whether the turnover (duplex) option is
installed.
MG ISO Type:
Loco
Hico
JIS Type:
Loco
Hico
Displays the coercivity value set using Printer
Manager for writing data to magnetic stripe cards (if
the magnetic stripe option is installed):
 Loco: 238 x 102 [A/m] (300[Oe])
 Hico: 218 x 103 [A/m] (2750[Oe])
Refer to “MagStripeGeneral” on page68 for more
information.
Retry Count:
0, 1, 2, 3
Displays the value set using Printer Manager. Refer
to “MagStripeGeneral” on page 68 for information
on setting the retry value.
Menu Display Settings Function

DataCard CR500 Specifications

General

Brand	DataCard
Model	CR500
Category	Printer
Language	English