Elrepho 3000
Job Edit Mode (cont)
# Avg. Reads Sets the number of readings to make and
average for each measurement. This
value can be between 1 and 30.
Print Mode When active, press PRINT once
to print all task data in a job’s
procedure.
View Area The measurement condition under
which samples will be measured.
Paper Basis Sets the paper basis weight used by the
scattering and absorption formula. This
value is specified in grams/meter
2
and
must be greater than zero. The Æ
key is
used to move through the digits.
Proc Used to select the procedure to use
for this job. When this field is
highlighted and the SEL key is pressed,
a list of available procedures will be
displayed. Select the desired procedure
and press the SEL key.
Job Only displayed if the current procedure
Standard contains tasks which require that
measurement data be compared to a
standard.
When this field is highlighted and the
SEL key is pressed, a list of available
procedures will be displayed. Select the
desired procedure and press the SEL
key.
Data Maintenance Mode
Datacolor International
31
To Next Page
Loading...
