Elrepho 3000
REMEASURE WHITE TILE - TOO DARK
This warning will be displayed during the white standard calibration
if the measured white standard is too dark. This usually indicates
that something other than the white standard is in position and was
measured. Check to ensure the white standard is positioned
correctly.
CLOSE VIEWER BEFORE MEASURING
This message is displayed if a measurement is attempted while the
viewer is in the “open” position. Close the viewer.
FLASH LAMP ERROR
This message indicates a possible instrument malfunction. Either
the flash lamp capacitor failed to charge or the lamp did not flash
when instructed. Please contact your Datacolor International
Service representative for further instructions.
LOW LIGHT LEVEL ERROR
This message indicates a possible instrument malfunction. The
energy detected on the reference channel was below the required
minimum. Please contact your Datacolor International Service
representative for further instructions.
ERROR SETTING UP MEASURE CONDITION
This message indicates an error occurred setting up a measurement
condition. This usually indicates a possible instrument malfunction.
Please contact your Datacolor International Service representative
for further details.
INVALID ILLUMINANT
This message indicates the illuminant to use by a task’s formula is
invalid. Many formulas are restricted in the illuminant/observer
combinations which can be used. When a task is setup, the
illuminant is checked to verify it is supported by the task’s formula,
therefore this error should not occur. If it does, report this problem
to your Datacolor International Service representative.
DIVISION BY ZERO
This message indicates the measurement data passed to the task’s
formula resulted in values which would result in division by zero.
Datacolor International
55
To Next Page
Loading...
