Datakom DK-45 - Page 12

DK-45 Kullanım Kılavuzu V1.0 (22.09.2016)
- 12 -
Information Screen
If the E.47 Motor Control PWM Signal is enabled, then instead of start/stop pressures, this screen will
show the E.48 Motor Control PWM Set Pressure (DRVR SET PRS) parameter.
Alarm history Screen
Alarm history will be described in detail in chapter 6.6.
Above screens or values shown in screens may not be displayed depending on program parameter
setup.
Display of some values are selected with program parameters.
Display screens may differ following compressor
manufacturers.
When an alarm occurs, the display will show the alarm code
and alarm symbol.