Datakom DK-45 - Alarms, Warnings, and Fault Codes; Alarm and Warning Indicators

DK-45 Kullanım Kılavuzu V1.0 (22.09.2016)
- 17 -
Abnormal conditions of a compressor are divided into 3 categories, being WARNINGS, ALARMS and
SERVICE REQUESTS.
Warnings are the lowest priority fault conditions and result only in visual warnings.
Alarms are highest level fault conditions and cause the compressor to stop immediately, the alarm relay
to operate (if enabled) and the controller give visual warning.
When a fault condition occurs, the related fault code and icon will appear on the screen. If the fault
condition is an alarm, then the ALARM led will turn on. If the fault is a service request then the SERVICE
led turns on.
Warnings may be cancelled by depressing the MENU pushbutton. Alarms cannot be cancelled with
pushbuttons. The alarm signal must also be removed. However the depression of the MENU
pushbutton will cause the large alarm icon to disappear and the alarm goes to the upper right corner of
the screen.
5. ALARMS AND WARNINGS
When the MENU pushbutton is depressed, the display will
rever to the “measurements” screen.