Datakom DK-45 - Electrical Parameters

DK-45 Kullanım Kılavuzu V1.0 (22.09.2016)
- 38 -
ICON and No:
DESCRIPTION
ADJUSTMENT LIMITS
Factory
Set
C.01
VOLT.UNBALANCE % :
Voltage unbalance ratio
% 0 ... 20
5 %
C.02
LOW VOLT. ALARM :
Low voltage alarm enable
0: disabled
1: enabled
If this parameter is set to 0 then the
parameter C.03 will not be visible.
1
C.03
LOW VOLT. ALARM :
Low voltage alarm limit
100 ... 600
360 V-AC
C.04
WIRING TOPOLOGY :
1: Single phase
2: Two phased
3: Three phased
3
C.05
PHASE L1 CONSTNT :
Phase L1 calibration
coefficient
1 ... 32767
1219
C.06
PHASE L2 CONSTNT :
Phase L2 calibration
coefficient
1 ... 32767
1219
C.07
PHASE L3 CONSTNT :
Phase L3 calibration
coefficient
1 ... 32767
1219
C.08
LOW FREQ. ALARM :
Low frequency alarm
enable
0: disabled 1: enabled
If this parameter is set to 0 then the
parameter C.09 will not be visible.
1
C.09
LOW FREQ. ALARM :
Low frequency alarm limit
10.0 ... 60.0
48.0 Hz
C.10
HIGH FREQ.ALARM:
High frequency alarm
enable
0: disabled
1: enabled
If this parameter is set to 0 then the
parameter C.11 will not be visible.
1
10.2.3. ELECTRICAL PARAMETERS