Enter/Exit Programming Mode
228
PowerScan™ PD9330/PBT9300/PM9300
Display Off Timeout
Sets the timeout for display, backlight and keyboard.
Display Off Timeout = Disabled
Set Display Off Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
le
ft followed by two digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the ENTER/
E
XIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and no
t save the entry string. You can then start again
at the beginning.
CANCEL
Backlight Enable
Enables/Disables the display backlight.
Backlight Disabled
Backlight Enabled
To Next Page
Loading...
Need help?
General
