Enter/Exit Programming Mode
232
PowerScan™ PD9330/PBT9300/PM9300
Arrow Keys Mode (4-key models only)
Configure the Arrow Keys functionality type. Two options are available:
Function Keys Action Select mode:
When in this mode, arrow keys are used to
select one of the 3 possible actions associated to the Function Keys. To
associate actions to the Function keys, see "Co
nfigure Actions for Function
keys" on page 234.
String Association Mode:
When in this mode, each one of the arrow keys can
be programmed to display and transmit a pre-defined string (see
"Arrow Up
String (4-key models only)" on page 232
and "Arrow Down String (4-key
models only)" on page 233
. Default string for Up and Down is ”=”.
Function Keys Action Select Mode
DEFAULT
String Association Mode
Arrow Up String (4-key models only)
Associate a pre-defined string to the Arrow Up key
Set string for Arrow Up Key
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
le
ft.
Define the label string by further scanning 32
digits from the Alphanumeric characters in
Appen-
dix D, Keypad
.
The digits must be the hexadecimal ASCII representa-
tion of the desired characters; if less than the expected
string of 16 charac
ters are selected, scan the ENTER/
EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and no
t save the entry string. You can then start again
at the beginning.
CANCEL