Datalogic PM9300 User Manual

Enter/Exit Programming Mode
238 PowerScan™ PD9330/PBT9300/PM9300
Define Strings
Configure string 1-5.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code at the top of
the page, then the bar code for the String you want to set. Define the label string by scanning 32
digits from the Alphanumeric characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representati
on of the desired characters; if less than
the expected string of 16 characters are selected, scan the ENTER/EXIT bar code to terminate
the string.
End by scanning the ENTER/EXIT bar code twice.
$CPWEP
Set String 1
$CPWEO
Set String 2
$CPWEA
Set String 3
$CPWEM
Set String 4
$CPWEL
Set String 5
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL

Datalogic PM9300 Specifications

General

Brand	Datalogic
Model	PM9300
Category	Barcode Reader
Language	English