Product Reference Guide
253
Chapter 4
References
This section contains explanations and examples of selected bar code fea-
tures. See Configuration Using Bar Codes, starting on page 21 for the actual
bar code labels used to configure the reader.
RS-232 PARAMETERS on page 254
• RS-232 Only on page 254
• RS-232/USB COM Parameters on page 256
KEYBOARD INTERFACE on page 263
• Wedge Quiet Interval on page 263
• Intercharacter Delay on page 264
• Intercode Delay on page 265
SYMBOLOGIES on page 266
• Datamatrix DPM Decoding Safety on page 283
• Set Length on page 266
DATA EDITING on page 268
• Global Prefix/Suffix on page 269
• Global AIM ID on page 269
• Label ID on page 271
• Character Conversion on page 275
READING PARAMETERS on page 276
• Good Read LED Duration on page 276
SCANNING FEATURES on page 277
• Scan Mode on page 277
• Stand Mode Off Time on page 296
• No trigger pull is required to read a bar code. Scanning
is continually on. If the trigger is pulled, the reader acts
as if it is in Trigger Single Mode. Double Read Timeout
prevents undesired multiple reads of the same label while
in this mode. on page 277
• . Symbology Hex Values on page 278
• . Symbology Hex Values on page 278
• Flash Off Time on page 300
• Multiple Labels Ordering by Code Symbology on page
301
To Next Page
Loading...
Need help?
General
