DNS1 Address Enter/Exit Programming Mode
Ethernet Software Reference Guide
21
DNS1 Address
This is the address of the preferred or primary DNS server for the
BC9180™. This server is used first, to resolve DNS names to IP addresses
for DNS names queried by this computer that cannot be resolved by
using local name resolution information (such as cached DNS names or
names contained in a Hosts file).
$CETD1
Set DNS1 address
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by 8
digits (in hex) from the Alphanumeric characters in
Appendix B, Keypad
representing your desired
character(s).
Exit programming mode by scanning the ENTER/
EXIT barcode a
gain.
Make a mistake? Scan the CANCEL bar code to abort
and
not save the entry string. You can then start
again at the beginning.
~
CANCEL
Default DNS1 address = 00000000,
hexadecimal representation of 0.0.0.0
To Next Page
Loading...
