Advanced Configuration Guide
13
Chapter 3
Handheld Configuration
This section provides additional programming bar codes to configure your reader by changing
the default settings. You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to Setup and follow the procedures described for your
handheld. Once the reader is set up, you can change the default parameters as needed for your
specific application.
PowerScan Configuration starting on this page
Gryphon Configuration starting on page 18
PowerScan Configuration
Optional Settings
The following settings are optional. They are applicable only to PowerScan handhelds in
PreScan Multi Lane Mode. Use them to customize the settings for your PreScan system.
Reference the PreScan Integration Guide for planning considerations when determining the
optimal configuration settings for your setup.
• PowerScan Keypad Enable/Disable on page 14
• Prompt Before Delete on page 14
• 60-Minute Data Timeout on Inactivity on page 15
• Beeper Control for Radio Response on page 15
• Radio and Communication Timeouts (for Base) on page 16
• “FIND ME” Function (Only for base models with button) on page 17
• Next Session Prompt on page 17
• Clear Session Memory on page 17
• Clear Handheld Memory on page 17
MODE B option
The Mode B option (=CT1 command) MUST be enabled according to the
RTS/CTS Hw handshake is enable (= CE1 command)
To Next Page
Loading...
