Datalogic PreScan - 60-Minute Data Timeout on Inactivity; Beeper Control for Radio Response

PowerScan Configuration
Advanced Configuration Guide 15
60-Minute Data Timeout on Inactivity
If a handheld unit is totally inactive for over 60 minutes, an option is available to clear that
device’s memory. It is recommended that this feature be enabled to prevent a build-up of
abandoned baskets.
Beeper Control for Radio Response
This feature offers the following options:
• Normal — Beep on good decode and good reception
•Off
• Beep only on good decode
• Beep only on good reception
CAUTION
Enabling this feature will clear all data from memory if the device is left
unused.
60 Minute Data Timeout on Inactivity = Disable
$+IQ0$-
60 Minute Data Timeout on Inactivity = Enable
$+IQ1$-
Beeper Control for Radio Response = Normal
$+BF0$-
Beeper Control for Radio Response = OFF
$+BF3$-
Beeper Control for Radio Response =
Beep only on good decode
$+BF1$-
Beeper Control for Radio Response =
Beep only on good reception
$+BF2$-