Advanced Configuration Guide
33
Chapter 4
Magellan Configuration
PreScan Configuration Options for Magellan
Basket Download Timing and Options
• First Label Delay on page 35
• Inter-Label Delay on page 37
• Per Label Beep Duration on page 40
• Start Basket Notification on page 43
• End Basket Notification on page 46
Options for PreScan Control Cards
• Enable/Disable Control Cards on page 49
• UPC with Prefix 4 on page 50
• EAN-13 with “24” on page 51
• Send Label on POS Enable on page 52
• Transmit Control Card Data to POS on page 53
• Transmit UPC-A Loyalty Card on page 54
• Transmit EAN-13 Loyalty Card on page 55
The following settings are optional and apply to PreScan Mode. To use the bar codes in this
section to program the Magellan scanner, you must first enter Programming Mode by scanning
the SWITCH bar code below. While in Programming Mode, scan the option(s) bar codes in
this section to configure the Magellan as desired. When finished, scan the SWITCH bar code
once again to exit Programming Mode and save the changes.
Cover any unused bar codes on this and the facing page to ensure that the scanner reads only the
bar code you intend to scan.
SWITCH BAR CODE
Enter / Exit Programming Mode
00000
To Next Page
Loading...
