What to do if Datalogic SC6000 Controller does not respond correctly to the external signal end?
If the Datalogic Controller does not respond correctly to the expected external signal end in On Line Mode and Serial On Line Mode, check the “Reading Phase Timeout” parameterization in the OPERATING MODES folder of the Genius™ software configuration program.
How to fix if data do not appear on the terminal from Datalogic SC6000 Controller?
If data do not appear on the terminal from Datalogic Controller, enable the DATA COMMUNICATION SETTINGS/MAIN- AUXILIARY PORT\DATA TX parameter in the Genius™ program.
How to troubleshoot Ethernet LED not lit on Datalogic SC6000 Controller?
If the Ethernet LED is not lit on the Datalogic Controller, verify the HUB connection and the Genius™ settings (see par. 3.4).
How to fix the “Power On” LED if it is not lit on Datalogic Controller?
If the “Power On” LED is not lit on the Datalogic Controller, check if the power is connected. If you're using a power adapter, ensure it's connected to the PWO 25-pin cable.
What to check if "PS” LED is not lit on Datalogic Controller?
If the "PS” LED is not lit on the Datalogic Controller in On Line Mode 1 (when the external trigger activates), carefully check if you are referring to the 25-pin connector of the PWO. Ensure the sensor is connected to the PWO PS input and that power is supplied to the photo sensor.
General| Model | SC6000 |
|---|---|
| RAM | 4 GB DDR3L |
| Storage | 64 GB SSD |
| Ethernet | 2 x Gigabit Ethernet |
| Input Voltage | 24 VDC |
| Serial Ports | 2 x RS232 |
| Video Output | HDMI |
| Connectivity | USB, Serial |
| Operating Temperature | -10°C to 50°C |
To Next Page
