Datamax MP Compact4 Mark II

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 115
STX KtA Write Application Family Identifier (AFI) to Tag
(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)
This command writes the AFI data to the tag.
Syntax:
<STX>KtAabcc
a
- The number of retry attempts, 0-9.
b
- Lock the Application Family Identifier (AFI) after writing:
0 = No Protection
1 = Write Protect
Where:
cc
- Two character AFI value representing one byte.
Sample:
<STX>KtA91C3[CR]
The sample above writes 0xC3 AFI byte, locking value, retrying
nine times if necessary.
STX KtD Write Data Storage Format Identifier (DSFID) to Tag
(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)
This command writes the DSFID data to the tag.
Syntax:
<STX>KtDabcc
a
- The number of retry attempts, 0-9.
b
- Lock the Data Storage Format Identifier (DSFID) after
writing:
0 = No Protection
1 = Write Protect
Where:
cc
- Two character DFSID value representing one byte.
Sample:
<STX>KtD91C3[CR]
The sample above writes 0xC3 DSFID byte, locking value, retrying
nine times if necessary.