AP20 Installation and Operating Guide Version 1.25
Appendix D: AP20 Product Specifications D-3 Document #: 9301H39200 Ver. 1.25
Audio Delays
Individual Channel Delays
0 - 1000ms
Global Delay
0 –1000ms)
Note: Total delay per channel not to exceed 1000ms
35mm Film Optical Soundtrack Audio Processing (with optional H338 PCB)
Built-in processing for mono, A-Type and SR noise reduction.
Matrix decoding LT/RT to left, center, right and surround
Optical bass extension with adjustable low-pass filter and gain.
2 projector inputs for change-over operation.
Automation control for change-over.
BNC connectors for external RTA and oscilloscope.
Graphical user interface for A-chain alignment including optical gain, slit-loss EQ, and azimuth.
Automation Inputs/Outputs
Connector: DB25 Female
16 bi-directional GPIO’s, optically isolated, mute and fader inputs
External +5v@140mA
Management
Remote Control
RS232 DB9 Female
10/100Mbps Ethernet
Can be controlled by smart phone, iPad, Android based devices via iRule or VNC
Crestron Integrated Device
Setup/Operation Profiles
Named profiles identifying inputs, output, filter and channel gain settings
Touchscreen or automation format switching
Export/Load of user profile to additional cinema processors with identical room setups (via USB)
Setup/Operation Profiles
Configurable for up to 20 user defined named input selections. Input selections include processing
options along with a selected named set for EQ and output channel profile.
Configurable for up 20 user defined named EQ sets which include definitions for Dirac
optimization, third octave EQ, parametric EQ, bass and treble controls.
Configurable for up to 20 user defined output channel profiles which include output channel
names, output routing, crossover high/low pass filters.
User defined input selections controllable by Touchscreen, GPIO, or ethernet
Export/Load of user configurations via USB
To Next Page
Loading...
