Datascope Accutorr Plus - Notes

Accutorr Plus Service Manual 0070-10-0691 ix
Notes Introduction
Notes
NOTE: See the serial and product number label on the
rear panel of the unit for part number
identification. This manual also includes
information on the optional Recorder and
Predictive Temperature modules and Infrared
Temperature module.
NOTE: This manual does not provide operating
instructions. Consult the Operating Instructions
Manual for proper operation of this monitor.
NOTE: Unauthorized servicing may void the remainder of
the warranty. Check with the factory or with a
local authorized representative to determine the
warranty status of a particular instrument.
NOTE: Do not change Room Number and /or Bed Letter
on the Accutorr Plus during the transmission of
temperature data.
NOTE: The AccuTemp IR thermometer should be at room
temperature when it is used. If it has been in a
very warm or very cold environment it may need
time for the thermometer temperature to equalize
to ambient temperature.
NOTE: Special care should be taken to insure that the
front panel and glare screen are not scratched.
NOTE: New batteries are shipped in a discharged state
for safety reasons. A new battery must be
charged for 4 hours for Li-Ion before first use. The
monitor may be used with AC mains power during
the charge cycle but battery operation could be
limited during this time.
NOTE: Mindray DS USA, Inc. maintains a policy of
continuous development for product improvement
and reserves the right to change materials,
specifications, and prices without notice.
NOTE: When replacing a Keyboard, you must replace the
Graphic Panel.
NOTE: Monitors with Nellcor
®
and Masimo
®
SpO
2
do not
report SpO
2
Runtime and Boot Software Versions.
NOTE: The Accutorr Plus always displays time in a 24
hour format.