Technical Manual
56
Inverter Set-up
Although spare and replacement inverters are generally set up prior to
despatch, the settings should be checked after fitting. Where any problems are
being experienced with the operation of the inverter, it is again worth checking
these settings.
WARNING:
Appropriate safe working practices should be followed to ensure
that all hazards are minimised. The pod contains cabling and
connectors that are at a potential of 240Vac when power is
connector to the unit.
To check the inverter settings are correct use the supply documentation
provided with the unit.
The data provided in Error! Reference source not found. overleaf lists the
function settings that should be present in the inverter drive unit during
normal operation.
Operational information
Where the pod is disassembled, all the o-rings should be checked to ensure
that none of them are damaged. It is recommended during reassembly, to use
a small amount of silicone grease on the o-rings to prevent damage.
To Next Page
Loading...