Daub DR Robot Variomatic - Connecting the Power Supply

DR Robot Variomatic | User manual www.daub.nl49
5.4. Connecting the machine
Check the following:
• A fuse with switch is placed within two metres of the machine.
• Acableglandwithclampingringisttedaroundthepowersupplycableatthecableentry
opening in the machine.
• The voltage and phases of the electrical connection are the same as those of the machine (see
type plate on the side of machine). Contact your supplier if this is not the case.
1. Connect the power supply cable.
ATTENTION
• The machine must be connected to a group protected by a class 1, type C residual-current
circuit breaker.
• The electrical diagram has been added to the switch box of the machine and can be requested
from Daub.