Daub DR Robot Variomatic - Changing the Dividing Disc

DR Robot Variomatic | User manual www.daub.nl54
Problem Solution
The dough balls are not of equal
weight.
Make sure the dough piece is put exactly in the middle of
theplateandattenitalittlebyhand.Thedoughshouldnot
come over the edge of the rounding plate.
Make sure the dough is pre-proofed for the correct length
of time (depends on the dough consistency, but usually 15
minutes).
Increase the pressing time. The pressing time can be read
in the display. As soon as the dough appears under the
pressing ring it has been pressed long enough.
The dough balls are not rounded
enough.
Reduce the weight setting with button 13.
Increase the rounding time by pushing button 9 on the
control panel.
Try a combination of both.
The dough balls have a point at the
top.
Increase the weight setting with button 14.
Check if the dough piece is in accordance with the capacity of
the machine.
The surface of the dough balls is
cracked.
The dough pieces have been rounded too long. Decrease the
rounding time with button 8 on the control panel.
The machine presses the dough
through the gap between the
rounding plate and the pressing
ring.
The dough piece has been pressed too long. Decrease the
pressing time.
The soft dough is being pressed to hard. Lower the pressure
(with the option pressure regulation).
ATTENTION
For good results, observe the machine's prescribed weight ranges. See the table for the correct
weight range.
7.8. Changing the dividing disc
7.8.1. Supplied tools
• Pipe spanner
7.8.2. Instructions
1. Turnothemainswitch.