Daub DR Robot Variomatic - Cleaning Under the Rounding Table; Ordering Spare Parts

DR Robot Variomatic | User manual www.daub.nl62
ATTENTION
Never use vegetable oil which will get hard.
9. Pressthetwostartbuttonsuntilthehydraulicunitshutsoandtheknifeisretracted.
10. Fit the pressing ring by turning it clockwise.
11. Tilt the dividing disc downwards.
12. Push the locking pin back in.
13. Fit the front and rear cover.
8.4. Cleaning under the rounding table
8.4.1. Required tools
• Brush
• Damp cloth
• Plastic scraper
• Compressed air
8.4.2. Instructions
1. Removetheroundingtablebyrmlystrikingitontheunderside.
2. Clean the area under the rounding table with a brush, damp cloth, plastic scraper or compres-
sed air.
3. Place the rounding table back in position, and make sure the round opening is correctly pres-
sedontothebearing.Presstheroundingtablermlyinplace.
4. Presstheroundingtablermlydownwardsandcheckifitislyingat.
ATTENTION
Theroundingtablemustlieat.
8.5. Spare parts
Order spare parts from your dealer or the Daub service department.
Haveaqualiedservicetechnicianinstallthespareparts.Otherwise,contactyourdealerorthe
Daub service department.