Daub DR Robot Variomatic - Understanding Error Notifications

DR Robot Variomatic | User manual www.daub.nl64
(*) If the problem is not solved, contact your dealer or the Daub service department.
9.2. Errornotications
Thefollowingfaultndingscouldappearinthedisplay:
Fault message Cause Solution
E1 (switch cover) The back cover is loose during
operation.
Attach the rear cover.
The back cover switch is
malfunctioning.
Replace the switch for the
cover. (*)
E2 (switch pressing ring) The end switch of the press
ring is malfunctioning.
Replace the limit switch for the
ring. (*)
Thepressingringisnottted. Fit the pressing ring.
The pressing ring is dirty and
does not contact the limit
switch in time.
Clean the pressing ring. (*)
E4 (thermal overload is
activated)
The hydraulic motor and
rounding motor have stopped.
Reset the relay by pressing
the blue button of the
corresponding relay in the
control cabinet.
E5 (emergency button is
pressed)
The emergency switch is on. Unlock this if there is no
danger
E6 (1 or 2 start buttons are
defective)
The start buttons aren't
touched simultaneously within
0,5 seconds.
Press the two start buttons
simultaneously.
(*) If the problem is not solved, contact your dealer or the Daub service department.