DEC 2000 - 2 2 Upgrading a Decsystem 5000 Model 133150; Upgrade Procedure; Step 3: Disconnect Cables; Step 2: Shut down System

Upgrade Procedure
2. Enter cnfg 3 at the console prompt (>>>). A screen similar
to the following appears:
>>> cnfg 3
3: KNO2 DEC Vn.n TCF0 (8 MB)
(enet: 08-00-2b-30-14-df)
(SCSI = 7)
-----------------------------------------------------
DEV PID VID REV SCSI ID
-----------------------------------------------------
rz2 RZ24 (C) DEC DEC 0700 DIR
rz5 Rrd42 (C) DEC DEC 0700 CD-ROM
This display shows an RZ24 drive set to SCSI ID 2 and an
RRD42 drive set to SCSI ID 5.
Write down the names of your system drives and SCSI ID
settings here. You will need them for future use.
Step 2: Shut
Down System
Turn off the system unit by pressing O on the On/Off switch on
the back of the system unit.
Caution: After you turn off the system, wait 15 seconds before
you unplug the power cord.
Step 3:
Disconnect
Cables
Disconnect all the cables from the back of the system unit.
Disconnect the power cord from the wall outlet and then from
the system unit.
2–2 Upgrading a DECsystem 5000 Model 133/150