Upgrade Procedure
Step 10: Set
SCSI IDs on
Drives
If your DEC 2000 AXP system has a factory-installed disk drive,
it is set to SCSI ID 0.
Check the SCSI ID settings you noted earlier. If one of the
drives you are upgrading is set to SCSI ID 0, then change that
setting. SCSI settings can be found in the DECpc AXP 150 and
DEC 2000 Model 300 AXP Customer Technical Information.
Step 11: Install
New Mounting
Bracket
You must install the mounting brackets included in your upgrade
kit onto the drives you remove from your current system.
Instructions for installing the mounting brackets are in the
DECpc AXP 150 and DEC 2000 Model 300 AXP Customer
Technical Information.
Step 12:
Complete the
Upgrade
Follow the instructions in the DECpc AXP 150 and DEC 2000
Model 300 AXP User Information and the DECpc AXP 150 and
DEC 2000 Model 300 AXP Customer Technical Information to
complete the upgrade.
Update the customer service contract to the DEC 2000 Model
300 AXP system.
Step 13:
Return Your
DECsystem to
Digital
Return your DECsystem and any devices that are not
upgradeable to Digital.
1. Pack the DECsystem and devices securely in packing
material.
2. Attach the return address label that was in your upgrade kit.
Upgrading a DECsystem 5100 5–11
To Next Page
Loading...
Need help?
General
