6
Upgrading a DECsystem 5500
Topics Covered
in This Chapter
• Upgrading your system
• Completing the upgrade
Upgrade Procedure
Step 1: If Your
System Has
Factory-Installed
Drives
If your DEC 2000 system has factory-installed drives, you may
need to change the SCSI IDs on the drives you are upgrading.
To display the SCSI ID settings of the drives in your expansion
box:
1. Enter the command to shut down the software and put the
system in console mode:
shutdown -h now
2. Enter
maint
at the prompt (>>).
3. Enter
show scsi
at the prompt (>>>).
Upgrading a DECsystem 5500 6–1
To Next Page
Loading...