DEC 2000 - Upgrading a DECsystem 5100; Topics Covered in This Chapter; Upgrade Procedure

5
Upgrading a DECsystem 5100
Topics Covered
in This Chapter
• Upgrading your system
• Removing drives
• Completing the upgrade
Upgrade Procedure
Step 1: If Your
System Has
Factory-Installed
Drives
If your DEC 2000 AXP system has factory-installed drives,
you may need to change the SCSI IDs on the drives you are
upgrading.
To display the SCSI ID settings of the drives in your DECsystem:
1. Enter the command to shut down the software and put the
system in console mode: shutdown -h now
2. Enter conf -s at the console prompt (>>>). A screen similar
to the following appears:
>>> conf -s
.
.
scsi peripherals
unit type product removable/fixed capacity
0 disk RZ56 (C) DEC fixed 634 MBs
3 disk RZ24 fixed 209 MBs
5 tape TZ30 removable
7 host adapter
Upgrading a DECsystem 5100 5–1