DEC 2000 - Step 2: Shut down System; Step 3: Disconnect Cables

Upgrade Procedure
2. Enter cnfg 3 at the console prompt (>>>). A screen similar
to the following appears:
>>> cnfg 3
3: KNO2 DEC Vn.n TCF0 (12 MB)
-----------------------------------------------------
DEV PID VID REV SCSI ID
-----------------------------------------------------
rz2 RZ24 (C) DEC 0700 DIR
rz5 RX26 (C) DEC 0700 SEQ
This display shows an RZ24 drive set to SCSI ID 2 and an RX26
drive set to SCSI ID 5.
Write down the names of your system drives and SCSI ID
settings here. You will need them for future use.
Step 2: Shut
Down System
Turn off the system unit by pressing O on the On/Off switch on
the back of the system unit.
Disconnect the power cord from the wall outlet and then from
the system unit.
Caution: After you turn off the system, wait 15 seconds before
you unplug the power cord.
Step 3:
Disconnect
Cables
Disconnect all the cables from the back of the system unit.
3–2 Upgrading a DECstation 5000 Model 20/25/33/50