DEC 2000 - Step 2: Shut down System

Upgrade Procedure
>> maint
>>>show scsi
SCSI Node 0
-tz(0,0*) (TLZ04)
SCSI Node 1
-rz(0,1,*) (RZ56)
.
.
>>>exit
>>
This display shows a TLZ04 set to SCSI ID 0 and an RZ56 set to
SCSI ID 1.
Write down your system drives and SCSI ID settings here. You
will need them for future use.
Step 2: Shut
Down System
1. To access the power switch, you must turn the keylock to the
bottom position. Pull the door open.
2. Turn off power switch.
Caution: After you turn off the system, wait 15 seconds
before unplugging the power cord.
3. Remove external cables.
6–2 Upgrading a DECsystem 5500