Upgrade Procedure
Step 4: Set
SCSI IDs on
Drives
If your DEC 2000 AXP system has a factory-installed disk drive,
it is set to SCSI ID 0.
Check the SCSI ID settings you noted earlier. If one of the
drives you are upgrading is set to SCSI ID 0, then change that
setting. SCSI settings can be found in the DECpc AXP 150 and
DEC 2000 Model 300 AXP Customer Technical Information.
Step 5:
Complete the
Upgrade
Follow the instructions found in the DECpc AXP 150 and DEC
2000 Model 300 AXP Customer Technical Information and DECpc
AXP 150 and DEC 2000 Model 300 AXP User Information to
complete the upgrade.
Step 6:
Return Your
DECsystem to
Digital
Return your DECsystem and any devices that are not
upgradeable to Digital.
1. Pack the DECsystem and devices securely in packing
material.
2. Attach the return-address label that was in your upgrade kit.
Step 7: Update
Service
Contract
Update the customer service contract to the DEC 2000 Model
300 AXP system.
Upgrading a DECsystem 3100 4–3
To Next Page
Loading...