Upgrade Procedure
2. Enter
test -c
at the console prompt (>>>). A screen similar
to the following appears:
>>> test -c
.
.
Unit(2) Device type 0 DISK
RME 0x0
Version 1
Response data format 1 CCS
Additional length 31
Vendor DEC
Product identification RZ24 (C) DEC
Firmware revision level 0700
Unit(1)
Unit(0) Device type 0 DISK
RME 0x0
Version 1
Response data format 1 CCS
Additional length 31
Vendor DEC
Product identification RZ24 (C) DEC
Firmware revision level 0700
>>
This display shows one RZ24 set to SCSI ID 0 and a second RZ24
set to SCSI ID 2.
Write down the names of your system drives and SCSI ID
settings here. You will need them for future use.
Step 2: Shut
Down System
Turn off the system unit. Disconnect the power cord from the
wall outlet and then from the system unit.
Caution: After you turn off the system, wait 15 seconds before
you unplug the power cord.
Step 3:
Disconnect
Cables
Disconnect all the cables from the back of the system unit.
4–2 Upgrading a DECsystem 3100
To Next Page
Loading...
Need help?
General
