Upgrade Procedure
This display shows an RZ56 set to SCSI ID 0, an RZ24 set to
SCSI ID 3, and a TZ30 set to SCSI ID 5.
Write down the names of your system drives and SCSI ID
settings here. You will need them for future use.
Step 2: Shut
Down System
Set the On/Off switch on the back of the system unit to the off
(O) position.
Caution: After you turn off the system, wait 15 seconds before
you unplug the power cord.
Step 3:
Disconnect the
Cables
Disconnect all the cables connected to the system unit.
5–2 Upgrading a DECsystem 5100
To Next Page
Loading...
Need help?
General
