Upgrade Procedure
2. Lift the left side of the drive until the tabs on the right side
clear the cutouts in the drive shelf.
3. Disconnect the SCSI and power cables from the back of the
drive.
4. Remove all drive mounting brackets by removing the screws
that secure the drive to the mounting bracket.
5. Set the drive aside on an antistatic mat.
Step 8: Set the
SCSI IDs on the
Drives
If your DEC 2000 AXP system has a factory-installed disk drive,
it is set to SCSI ID 0. Check the SCSI ID settings you noted
earlier. If one of the drives you are upgrading is also set to SCSI
ID 0, change that setting.
SCSI settings for drives can be found in the DECpc AXP 150 and
DEC 2000 Model 300 AXP Customer Technical Information .
Step 9: Install
New Mounting
Bracket
You must install the mounting brackets included in your upgrade
kit onto the drives you remove from your current system.
Instructions for installing the mounting brackets are in the
DECpc AXP 150 and DEC 2000 Model 300 AXP Customer
Technical Information.
Step 10:
Complete the
Upgrade
1. Instructions for installing options that you have removed
from your current system can be found in the DECpc AXP
150 and DEC 2000 Model 300 AXP Customer Technical
Information. Follow the instructions in the DECpc AXP 150
and DEC 2000 Model 300 AXP User Information to complete
the upgrade.
2. Update the customer service contract to the DEC 2000 Model
300 AXP system.
Step 11: Return
Your MicroVAX
to Digital
Return your MicroVAX system and any devices that are not
upgradeable to Digital.
1. Pack the MicroVAX system and devices securely in packing
material.
2. Attach the return-address label that was in your upgrade kit.
Upgrading a MicroVAX 3100 Model 40/80/90, VAX 4000 Model 100 10–5
To Next Page
Loading...
Need help?
General
