10
Upgrading a MicroVAX 3100 Model
40/80/90, VAX 4000 Model 100
Topics Covered
in This Chapter
• Upgrading your system
• Removing drives
• Completing the upgrade
Upgrade Procedure
Step 1: If Your
System Has
Factory-Installed
Drives
If your DEC 2000 Model 300 AXP system has factory-installed
drives, you may need to change the SCSI IDs on the drives you
are upgrading.
To display the SCSI ID settings of the drives in your system:
1. Shut down your software following the instructions in your
software documentation.
2. Enter
SHOW CONFIG
at the console prompt (>>>). A screen
similar to the following appears:
Upgrading a MicroVAX 3100 Model 40/80/90, VAX 4000 Model 100 10–1
To Next Page
Loading...