7
Upgrading a MicroVAX 3100 Model 30
Topics Covered
in This Chapter
• Upgrading your system
• Removing drives
• Completing the upgrade
Upgrade Procedure
Step 1: If Your
System Has
Factory-Installed
Drives
If your DEC 2000 AXP system has factory-installed drives,
you may need to change the SCSI IDs on the drives you are
upgrading.
To determine the SCSI ID settings on your drives:
1. Shut down your software following the instructions in your
software documentation.
2. Enter the
SHOW CONFIG
command.
Upgrading a MicroVAX 3100 Model 30 7–1
To Next Page
Loading...
Need help?
General
