DeDietrich AWHP MIT-IN iSystem Installation And Service Manual

4. The screen displayed is used to select the numbers of the slave
VMs to be removed from the network. Turn the rotary button to
scroll through the numbers and press to remove the number
chosen. Press
j
to go back to the previous list.
5. Select NB. ELEMENTS.NETWORK. This screen summarises the
elements in the network recognised by the system. Press
j
to go
back to the previous list.
5.6.5. Return to the factory settings
To reset the appliance, proceed as follows:
1. Press key
C
,
>
and
j
simultaneously for 4 seconds. The menu
#RESET is displayed.
2. Set the following parameters:
Menu #RESET
Choice of generator Parameter Description
GENERATOR RESET TOTAL
Performs a TOTAL RESET of all parameters
EXCEPT PROG.
Performs a parameter RESET but retains the timer programmes
PROG.
Performs a RESET on the timer programmes but retains the parameters
SENSOR SCU
Performs a RESET of the generator sensors connected
ROOM SENSOR
Performs a RESET of the room sensors connected
After reset (TOTAL RESET and RESET EXCEPT PROG.), the
control system goes back to the display of the language choice after
a few seconds.
1. Select the desired language by turning the rotary button.
2. To confirm, press the rotary button.
bar
1
1
2
2
r
c
STD
(
'
t
v
0 2 4 6 8 10 12 14 16 18 22 2420
p
b
AUTO
x c
r
j
M
g
m
MODE
SUNDAY 11:45
C002296-B-04
4"
+ +
Français - Deutsch - English -
Italiano - Espanol - Nederlands
- Pycck - Polski - Türk -
bar
1
1
2
2
r
c
STD
(
'
t
v
0 2 4 6 8 10 12 14 16 18 22 2420
p
b
x
c
r
g
m
ÿ
LANGUE FRANCAIS
C002286-C
AWHP MIT-IN iSystem
5. Commissioning
24/09/2012 - 300027606-001-01
102

DeDietrich AWHP MIT-IN iSystem Specifications

General

Brand	DeDietrich
Model	AWHP MIT-IN iSystem
Category	Heat Pump
Language	English