After Sales level - Menu #REVISION
Parameter Adjustment range Description
REVISION TYPE NO
Factory setting
No message indicating that maintenance is necessary
MANU
Recommended setting
Signals that maintenance is necessary on the date selected. Set the date using the
parameters below.
AUTO
a Not applicable. Do not select this setting.
REVISION HOUR
(1)
0 to 23 Time at which the REVISION display appears
REV. YEAR
(1)
2008 to 2099 Year in which the REVISION display appears
REVIS. MONTH
(1)
1 to 12 Month in which the REVISION display appears
REVISION DATE
(1)
1 to 31 Day on which the REVISION display appears
(1) The parameter is only displayed if MANU is configured.
Clearing the maintenance message:
After carrying out the maintenance operations, modify the date in the
#REVISION menu to clear the message.
In the event of maintenance before the maintenance message is
displayed:
After carrying out early maintenance operations, it is necessary to set
a new date in the #REVISION menu.
7.4.2. Contact details of the professional for After
Sales Support
In order to assist the user if an error or service message is displayed,
it is possible to provide the contact details of the professional to be
contacted. To input the professional's contact details, proceed as
follows:
1. Access the "After Sales" level: Hold down the
-
key until
#PARAMETERS is displayed.
2. Select the menu #SUPPORT.
4
Turn the rotary button to scroll through the menus or
modify a value.
4 Press the rotary button to access the selected menu
or confirm a value modification.
¼
For a detailed explanation of menu browsing, refer
to the chapter: "Browsing in the menus", page 75
3. Set the following parameters:
After Sales level - Menu
#SUPPORT
Parameter Description
NAME
Input the installer's name
TELEPHONE NUM.
Input the installer's telephone number
bar
1
1
2
2
r
c
STD
(
'
t
v
0 2 4 6 8 10 12 14 16 18 22 2420
p
b
AUTO
x
c
r
j
M
g
m
SUNDAY 11:45
10
"
TEMP.: _ _ _ _
C002272-C-04
AWHP MIT-IN iSystem 7. Checking and maintenance
24/09/2012 - 300027606-001-01
106