EasyManuals Logo

Deif XL Installation And Commissioning Guide

Deif XL
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
1. Overview
This document contains guidelines for mounting, connecting and commissioning the XL or  indicators. Wiring
diagrams and mounting instructions for each indicator group are documented in separate chapters. The commissioning
chapter contains commissioning instructions for all indicator groups based on the input type for the indicator.
1.1 Legal information amd safety
1.1.1 Third party equipment
DEIF takes no responsibility for the installation or operation of any third party equipment.
1.1.2
Disclaimer
DEIF A/S reserves the right to change any of the contents of this document without prior notice.
The English version of this document always contains the most recent and up-to-date information about the product. DEIF
does not take responsibility for the accuracy of translations, and translations might not be updated at the same time as the
English document. If there is a discrepancy, the English version prevails.
1.1.3
Copyright
©
Copyright DEIF A/S. All rights reserved.
1.1.4
Electrostatic discharge
The indicator is protected against ESD (static electricity). Therefore, no special attention to ESD is needed during the
mounting and wiring of the indicator.
1.2 Package contents
The  indicators are delivered in a cardboard box. To protect the indicator it is important to store it in the box
until mounting.
For the XL types, the box also contains a number of fixing clamps. The exact number of clamps depends on the indicator
size and the degree of IP protection.
If the indicator is mounted for IP66 protection, a gasket (blue) for IP66 protection will be included. The contents should be
as described in the table below.
For bulkhead mounted types  the box also contains a bracket with two 8 x 12 mm screws for fixing the bracket
on the bulkhead box  mm Allen key).
Summary of package contents for each indicator
Content
XL72 XL96 XL144 XL192 BW144 BW192 BRW-2
Quick guide 1 1 1 1 1 1 1
Indicator 1 1 1 1 1 1 1
Terminals, see note below 2/3 2/3 2/3 2/3 2/3 2/3 2/3
Rear mounted version, fixing clamps IP52/IP66 2/4 2/4 4/8 4/8
Gasket IP66 option 1 1 1 1
Front mounted version, frame 1 1 1 1
Installation and commissioning guide 4189350024O EN Page 4 of 39

Table of Contents

Other manuals for Deif XL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Deif XL and is the answer not in the manual?

Deif XL Specifications

General IconGeneral
BrandDeif
ModelXL
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals