DLS / DLS-C Series
103
Cod.: 240.010.0042
9.3 Uninstall
Before starting any maintenance operations, make sure that the system has been switched off, and that the
AC line external main switch has been set to off.
Wait at least 10 min. before removing the DLS system from the wall.
The inverter enclosure could overheat during its operation and cause burns by contact.
Do not carry out other operations on the inverter for at least 10 minutes. The inverter contains capacitors
that need a minimum time to discharge.
Batteries produce electricity and can cause electric shock or re in the event of a short circuit or incor-rect
installation.
The conductors from the solar panels are always live. The voltage from a string of solar panels can reach
1000 V!!
1. Disconnect the battery cable connectors from the BAT inputs.
2. Disconnect the DC connectors of the photovoltaic panel strings from the inputs PV1 and PV2.
3. Open the connection compartment by removing the xing screws.
4. Disconnect the GRID IN, GRID OUT and AC OUT (if present) conductors.
5. Disconnect the communication wires and external controls where present.
6. The DLS can now be removed for disposal or repair.
9.4 Disposal
To comply with the 2002/96 / EC European Directive relating to electrical and electronic waste and its im-
plementation as national law, electrical equipment that has reached the end of its useful life and dis-char-
ged batteries must be separated from general waste and disposed to the appropriate authorized col-lection
and recycling centers.
Any device that is no longer needed must therefore be returned to the distributor or disposed to an au-
thorized collection and recycling center in your area. Ignoring this European Directive can have potential-ly
negative effects on the environment and your health!
To Next Page
Loading...