Delios DLS 300 - Wi-Fi Connection

60
Cod.: 240.010.0042
DLS / DLS-C Series
See the connection instructions shown in Figure 16.
5.9 Wi-Fi Connection
By using a Wi-Fi dongle, the DLS inverter can access a local Wi-Fi network allowing to activate the re-mote
connection and system monitoring functions.
See the connection instructions shown in Figure 17.
Insert the Wi-Fi dongle supplied with the inverter accessories the USB port and wait for the system to reco-
gnize the device (transparent Wi-Fi icon).
WARNING: Use only the Wi-Fi dongle supplied with the inverter accessory. The correct functioning
of Wi-Fi connectivity is not guaranteed with not approved similar devices.
To set the correct operation of the connection it is necessary to access the conguration menu "SETTINGS"
and set the networking parameters of the "WLAN" menu according to the characteristics of the local net-
work to be accessed. Refer to the SYSTEM PROGRAMMING - NETWORKING section.
To ensure optimal Wi-Fi connectivity, make sure that the Wi-Fi signal available near the installation of the
DLS system is high enough to allow a stable connection. For this purpose, during the conguration of the
network parameters, the scanning and selection of the Wi-Fi network carried out by the DLS reports the signal
strength of the wireless network to which you intend to connect and the select network with signal strength S>
- 60dBm. If the detected signal is weak (S <-60dBm), the connection is not guaran-teed and therefore
it is necessary to provide for the use of a Wi-Fi repeater.
If the conguration operations are carried out correctly, the effective connection to the local Wi-Fi network is
shown by the Wi-Fi icon (icon highlighted) on the status bar of the display and by the stable lighting of the
blue LED on the control panel.