Figure 1 Opening the console
Removing the front bezel
About this task
NOTICE You must remove the disk enclosure’s front bezel to gain access to the disks. The
bezel is required for EMI compliance when the enclosure is powered up. Remove it only to
replace or add a disk.
Procedure
1.
If the bezel has a lock, insert the key that shipped with your enclosure into the lock, and turn
the key to unlock the bezel.
2. Press the two latch buttons on the bezel surface to release the bezel from the cabinet.
3. Pull the bezel off the cabinet and put it on a clean, static-free surface.
FRU Removal and Replacement
18 Dell EMC FS25 SSD Shelf Guide Field Replacement Unit Guide
To Next Page
Loading...
