Figure 32 Installing a disk
SAS
300GB
10k
SAS
300GB
10k
CL4720
Removing a disk filler module
About this task
Refer to Figure 33 on page 44 while performing the procedure that follows.
Procedure
1.
Insert your finger into the cutout on the bottom of the disk filler module.
2. With your thumb push the release latch on the top of the disk filler module down, and pull
the disk filler module out of the slot.
Figure 33 Removing a disk filler module
Installing a disk filler module
About this task
Refer to Figure 34 on page 45 while performing the procedure that follows.
Procedure
1.
Insert your finger into the cutout on the bottom of the disk filler module.
2. With your thumb on the top of the disk filler module push the disk filler module into the slot
until it clicks into place.
Replacing a 25-Slot Disk-Array Enclosure
44 Dell EMC FS25 SSD Shelf Guide Field Replacement Unit Guide