Figure 7 LCC fault LED
About this task
NOTICE The DAE must have at least one LCC installed while the enclosure is powered up; do
not remove both LCCs while AC power is on.
Procedure
1.
Attach an ESD wristband to your wrist and the enclosure.
2. Remove each cable connected to the LCC by gently pulling the connector latches to release
the cable from the connector.
Note where the cables connect to the LCC because you will reconnect them later.
Figure 8 Disconnecting an LCC cable
3. Remove the LCC:
FRU Removal and Replacement
22 Dell EMC FS25 SSD Shelf Guide Field Replacement Unit Guide
To Next Page
Loading...
