Figure 34 Installing a disk filler module
Attaching an AC power cord
About this task
The enclosures will start immediately when connected to active AC power.
Procedure
1.
Plug the power cords into the connectors on the power/cooling modules.
2. Attach the retention bail (strain relief) to the base of the power cords.
The retention bail prevents the power cord from pulling out of the connection.
Figure 35 Attaching power cords
Verifying the status of the replacement DAE5S
Procedure
1.
Verify that both LCC power LEDs are lit.
Replacing a 25-Slot Disk-Array Enclosure
Dell EMC FS25 SSD Shelf Guide Field Replacement Unit Guide 45
To Next Page
Loading...
