Dell EMC PowerEdge R440 - Installing the Expansion Card into the Expansion Card Riser

Installing the expansion card into the expansion card riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installing a new expansion card, unpack it and prepare the card for installation.
NOTE: For instructions, see the documentation accompanying the card.
3 Remove the expansion card riser.
Steps
1 Open the PCIe card holder latch.
2 If installed, remove the ller bracket.
NOTE: Store the ller bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certication of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airow inside the system.
Figure 65. Removing ller bracket for riser 2
108
Installing and removing system components