Installing power interposer board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the slots on the PIB with the guides on the system.
2 Using a Phillips #2 screwdriver, replace the two screws to secure the PIB to the system.
3 Route the cables and connect it to the system board.
Figure 98. Installing power interposer board
Next steps
1 Install the PSU.
2 Install the air shroud.
3 Follow the procedure listed in After working inside your system.
Related links
Installing a power supply unit
Installing the air shroud
Control panel
A control panel allows you to manually control the inputs to the server.
Your system supports:
• Left control panel: Contains status LEDs, system ID button, and iDRAC Quick Sync 2 (optional).
• Right control panel: Contains power button, USB 2.0 port, micro USB for iDRAC Direct, and status LED for iDRAC Direct.
Removing the left control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
136
Installing and removing system components
To Next Page
Loading...
