Figure 25. Installing the air shroud
Next step
1 Follow the procedure listed in After working inside your system.
Cooling fans
The cooling fans are integrated into the system to dissipate the heat generated by the functioning of the system. These fans provide
cooling for the processors, expansion cards, and memory modules.
Related links
Thermal restriction matrix
Removing the cooling fan
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the internal riser.
5 Disconnect the fan cable from the system board.
6 Move the cables out of the way to access the cooling fan cable connector on the system board.
Steps
1 Press the tabs on the side of the cable connector to disconnect the cable from the connector on the system board.
NOTE
: In the 4 x 3.5 inch hard drive system, disconnect the fan 1 cable from the power interposer board.
70 Installing and removing system components
To Next Page
Loading...
