Dell EMC PowerEdge R440 - Installing PERC Card into the Internal PERC Riser; Expansion Cards and Expansion Card Risers

Installing PERC card into the internal PERC riser
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Insert the PERC card into the internal PERC riser and push the card in.
2 Using a Phillips #2 screwdriver, replace the screw to secure the PERC card on the internal PERC riser.
Figure 54. Installing PERC card into internal PERC riser
Next steps
1 Install the internal PERC riser.
2 install the air shroud.
3 Follow the procedure listed in After working inside your system.
Related links
Installing the internal PERC riser
Expansion cards and expansion card risers
An expansion card in the system is an add-on card that can be inserted into an expansion slot on the system board or a slot on a riser card
to add enhanced functionality to the system through the expansion bus.
NOTE
: A System Event Log (SEL) event is logged if an expansion card riser is not supported or missing. It does not prevent your
system from turning on. However, if a F1/F2 pause occurs and an error message is displayed.
96 Installing and removing system components